Short Handle Soft Flex Professional Tool Set

$180.85
Be the first to leave a review
SKU SF-200SET
Height 3.75 (in)
Width 5.88 (in)
Depth 1.00 (in)
Stock
Wishlist

Create Wishlist

Size chain nose: length: 5.65in - pliers edge: 28mm - handle: 4in

Size cutters: length: 4.75in - cutting edge: 8mm - handle: 2.5in

Size round nose: length: 5.65in - pliers edge: 28mm - handle: 4in

 

SAVE $40.00 WHEN YOU BUY THE ENTIRE SET! This professional tool set includes the Soft Flex© Professional Chain Nose Pliers, Flush Cutters and Round Nose Pliers.

Quality That You Can Trust!

The Soft Flex© Chain Nose Pliers are manufactured for the professional wire worker. These pliers have an "eased edge" with a slight bevel to protect your wire when creating a sharp angle. Chain Nose Pliers are great for bending, creating perfect 90 degree angles, gripping and shaping wire. They are a must for all wire workers.

The Professional Soft Flex© Flush Cutters are manufactured by Soft Flex© Company for our top of the line, bead stringing wire: Soft Flex© Wire and Soft Touch Wire. This cutter will cut all 4 of our diameters: .010, .014, .019 and .024. They will also cut stainless steel, tungsten and nickel in diameters up to .065 mm. The blade exceeds 64 on the Rockwell Hardness Scale. Each cutter is hand tested and will get up to about half a million cuts!

The Soft Flex© Round Nose Pliers are manufactured for the professional wire worker. Round nose pliers are great for bending, creating loops and shaping wire.

These tools are manufactured in the USA. These tools are constructed of high grade alloy steel with ergonomic foam cushion handles. They have a lap-joint.

A tool is deemed ergonomic if it materially contributes to reducing the probability of cumulative trauma disorders with the hand, finger, wrist, or arm. The Soft Flex© Company Tool Line has handles designed for transferring force from the operator to the point of operation in a highly ergonomic manner. The average American worker`s hand or palm is approximately four inches wide. Therefore tool handles should be four inches long at least. To allow freedom of hand placement, 4 to 5 inches would be even more desirable. The length of our handles, from the joint to the end, is 4.5 inches. The long handle forces the operator to spread the force with use by all four fingers to operate the tool. Operators may use only two or three fingers on cutters with shorter handles. The longer handle also spreads the load over the width of the palm in a bar of force. In contrast, a short handle presents a point of force which digs into the palm, compressing nerves and tendons and reducing blood flow.

The Soft Flex© Company Tool Line features, as standard, a unique double-sheathed, ESD safe, cushioned grip. The inner sheath is a tough vinyl, ESD safe material which holds the leaf spring and the cushioned surface to the handle. The outer sheath, also ESD safe, provides a no-slip, cushioned surface for the operator`s hand. This is important because the slight compressibility of the cushion aids to distribute the pressure more effectively. It can even absorb sharp particles that might puncture the hand. The Soft Flex© Company Tool Line's cushion grip is almost always considered by operators to be more comfortable than the hard plastic used by competitors.