Size: 5.75in-L x 2.25in-W x 3/8in-D
Hole size starts at 8mm graduates down to 1mm

Draw plates are handy if you enjoy knitting with a knitting spool or Lazee Daizee Viking Knit Wire Weaving Tool. When knitting, the wire will have a free flowing knit. Pulling your design through the holes on the board will shrink the diameter down to the size of that hole. Using a Draw Plate will also make your design longer as it compacts down, that means you will end up using less wire than you would have if you did not use a Draw Plate – a good way to economize your wire. If you are producing a number of designs and need to maintain the same size every time, this tool will be an invaluable addition.

Note: This draw plate works with a Lazee Daizee Viking Knit Wire Weaving Tool 1/4" but it is too small to handle a design created on the Lazee Daizee Viking Knit Wire Weaving Tool 1/2".